How exactly do you specify the arguments to disable transportmode? Everything I tried just says "ERROR_ARGUMENT" Here is the job in ToolSet32 that I am trying to run (energiesparmode): ![]() I would think I should be able to disable this annoying mode on my module with at least one of these pieces of software but I have only found a reference to this mode in ToolSet32 and I am not sure how to specify the arguments to get that to work. I have INPA/EDIABAS, NCS Expert, and ToolSet32 all working and communicating with my E53. A low battery voltage in my ’03 X5 3.0 (E53) caused my main body module (ZKE3_GM4) to go into energy savings mode (also known as transport mode), so I lost windshield wipers, interior light, back hatch release, central locking, etc. ![]() I’ve been going through a steep learning curve on BMW diagnostic software over the last 2 weeks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |